Carl 3-D Bedienungsanleitung PDF herunterladen (Seite 12)

12

Align the aileron control horn Using

the line you drew earlier for the

pushrod slot. Mark the location of

the holes and drill two 5/64” holes.

Install the horn with two 2mmx20mm

screws and the nylon plate on top.

Locate one of the 2mm pushrods

with clevis. install the silicone keep-

er over the clevis and attach to the

control horn. With the aileron cen-

tered and the aileron servo cen-

tered, mark the location of the bend

over the output hole in the servo arm.

Bend at 90 degrees and cut off at

3/8”. The servo arm will need to be

drilled with the 5/64” drill. Install

the pushrod through the servo arm

and retain with a nylon snap-r-keep-

er. Repeat for the other aileron.

Mount the switch for the radio just

behind the radio compartment open-

ing on the left side of the plane.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

Kommentare zu diesen Handbüchern

Keine Kommentare